Does the granulator not discharge? Is production affected for a period of time?
Author: Bsrwood | Release time：2020-01-26
A few days ago, a farmer left a message to the author and asked, "why does the feed granulator feel less durable after a period of time?" The output feeling is lower than before, even unexpected. Is that the reason? "To this end, the author summarizes the following points to see if you have the same situation. Let's discuss:
1. Blockage of feed inlet and die hole of feed granulator may reduce the working efficiency of feed granulator
If your feed granulator has low output or no discharge, you can check whether the feed inlet and screen of the feed granulator are blocked. Generally speaking, the feeding port of flat mold pellet feeder is vertical, so if it is blocked, it can be seen directly. However, for the ring mold pellet feeder, although it is equipped with a forced feeder, it may also cause the feed blockage in the narrow conditioner.
The same is true for die hole plugging. Once the die hole is blocked, it's easy to clean it up a little, and it's troublesome if the blocking area is large. Therefore, we suggest that before using the feed granulator, oil should be used to pass through the feed granulator to ensure lubrication, and before the pelletizing work is completed, oil should be used to pass through the feed granulator to prevent mold hole blockage.
2. The influence of feed materials on the output of feed granulator
As we all know, the feed granulator is a kind of feed machine which can dry in and out. If the moisture content in the raw material is high, it will not form particles. If the water content is too small, it is difficult to press together to form particles. Generally speaking, we require that the moisture content of feed materials in the granulation process should not exceed 12 points. If the material is too dry, we can use hair conditioner and other auxiliary equipment.
3. The gap between the pressing roller and the ring mold of the feed granulator is not suitable, which leads to the low output of the feed granulator
In the feed machinery, some accessories will be worn after long-term use, such as the hammer of the feed grinder and the pressure roller of the feed granulator. In the long-term backlog of feed in the process, it is inevitable to wear. At this time, it is necessary to check the inner wear of the ring mold and the press roll to determine the reason for the low output of the feed granulator.
4. Low voltage may also lead to the output of feed granulator
Generally, farmers are in remote areas with a certain distance from the village, and the voltage used may be unstable. Therefore, if the above possibility is ruled out, granulation can be done outside the peak period of power consumption to see the effect. If the feeding is slow and the granulation speed is fast, it can be adjusted appropriately. You can also call the manufacturer of the purchased feed granulator to answer questions.